Daewoo Nexia

since 1994 of release

Repair and car operation


Deu Neksiya
+ Maintenance instruction
+ Maintenance
+ Engine
+ 3. Engine (two top camshafts)
+ cooling System
+ Toplevnaya and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. Electronic control unit and sensors
+ Transmission
+ 10. Five-speed transmission and main RPO MM5 broadcast
+ 11. Automatic Transmission
+ Steering
+ Running gear
- 14. Forward suspension bracket
   14.2. General description
   14.3. Check of size of forces of a friction in a suspension bracket
   14.4. Check of a condition of bearing support and spherical hinges
   14.5. Stabilizer
   14.6. A rack assembled with a bearing support
   14.7. Bottom lever
   14.8. Spherical hinge
   14.9. Nave and wheel bearing
   14.10. Top support
   14.11. Springs
   14.12. Shock-absorber
   14.13. Plugs of hinges of the bottom lever
+ 15. Drive of forward wheels
+ 16. Back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment


8128da4b



14.11. Springs
GENERAL INFORMATION

Adaptations for spring compression


Arrangement of a support of a spring


To remove or disconnect

PERFORMANCE ORDER
1. Top support.
2. To dismiss the spring compressed in the adaptation, to remove and replace.

To establish or attach

PERFORMANCE ORDER
1. To put on a new spring a rack and to compress it by means of adaptations KM-465A and KM-329А. The end of a spring should lean on the bottom cup of a rack. The springs established on the right and left are resistant, interchangeable. The ledge on a plastic support of a spring serves as a reference point at rack installation. If to look in the direction of movement of the car, the ledge on a support of the left rack should settle down in front, and on a support of the right rack – behind.
2. Top support of a rack.